Keep Your Plant Striving For New Heights
Cutting
Edge Solutions' Uncle John's Blend is a complex Potassium formula that
is used primarily to enhance a plant's metabolic rate, especially for
flowering plants during the blooming stage.
Potassium
is a major component in photosynthetic processes, including the
production of ATP (plant sugars) and the transfer of those sugars
throughout the plant tissue. Potassium also helps regulate C02 uptake,
as well as playing a major role in the regulation of plants. The low
molecular weight of UJB makes it very available to the plant for
immediate use, as well as making a very "clean" foliar spray that will
not leave heavy built-up or residue on the plant tissue. Uncle John's
Blend can also be used in conjunction with CES's 2 other additives Plant
Amp and Mag Amp for custom foliar applications.
Uncle
John's Blend can be used throughout the entire growth cycle, but is
more critical in the flowering stages of a plant's life to maintain
energy levels and maximize plant growth. A plant is essentially "dying"
as it goes to fruit or seed, adding UJB helps to maintain the metabolic
rate of plants that are in some cases not producing as much ATP towards
the end of its blooming/fruiting stage.
Uncle
Johns Blend is designed for use in hydroponics, soilless, continuous
feed, drain to waste, and for use in soil growing applications.
Guaranteed Analysis
Potassium (K) 2.0%
Derived from Potassium Sulfate Iron (Fe) 0.1%
Derived from Ferrous Sulfate
Mixing Instructions
For Hydroponics, foliar feeding, and soil applications:
10 ml Uncle John's Blend per gallon of water
Directions For Use
This
is a highly concentrated solution. Never mix undiluted concentrates, as
this may result in nutrient lock-up. Add each nutrient consecutively,
allowing ample time for each concentrate used to thoroughly dilute and
mix into the water. If preparing a nutrient stock tank, to be used over a
period of time exceeding 24 hours, you must aerate nutrient reservoir
regularly.
Shake well and measure carefully using a milliliter measuring cup.
If using Micro 6-0-0™, add Micro 6-0-0™ first to water, then other nutrients.
After
nutrients are mixed in water, adjust pH to 4.5-6.5. If your pH
naturally falls within these parameters, pH adjustment is not necessary.
Monitor ppm and EC in reservoir and top off with fresh water as needed. Reservoir temperature should be 60-68 degrees F.
Do not store product in direct sunlight. Do not freeze.
**Note** This Product Not Sold In Oregon.