Build Stronger Cell Walls And Boost Resistance to Stress and Diseases Organically
Cutting
Edge Solutions Plant Amp, which has been OMRI certified and registered
with the CDFA, is a chelated calcium product that also contains a
proprietary organic plant stimulating ingredient. Calcium is the basis
of cell wall development in a plant and essential in metabolic
processing of nutrients and functiong of enzymes and hormones. The
chelated calcium in Plant Amp is extremely soluble, providing an easily
utilized source of calcium. Plant Amp is 100% organic and can be used
throughout the entire growth cycle to optimize a plants growth.
Plant
Amp is formulated for use in hydroponics, soilless, continuous feed,
drain to waste, and for use in soil. Plant Amp can be applied at every
watering in conjunction with any of Cutting Edge Solutions® products, or
other commercially available hydroponic nutrients. Plant Amp is also a
fantastic foliar spray, due to its low molecular weight for uptake, but
also because it is very "clean" leaving no heavy build-up or residue on
the plant.
Guaranteed Analysis:
Calcium (Ca) 1.0%
Derived from Calcium Chloride
Directions for use:
This
is a highly concentrated solution. Never mix undiluted concentrates, as
this may result in nutrient lock-up. Add each nutrient consecutively,
allowing ample time for each concentrate used to thoroughly dilute and
mix into the water. If preparing a nutrient stock tank, to be used over a
period of time exceeding 24 hours, you must aerate nutrient reservoir
regularly.
Shake well and measure carefully using a milliliter measuring cup.
If using Micro 6-0-0™, add Micro 6-0-0™ first to water, then other nutrients.
After
nutrients are mixed in water, adjust pH to 4.5-6.5. If your pH
naturally falls within these parameters, pH adjustment is not necessary.
Monitor ppm and EC in reservoir and top off with fresh water as needed.
Reservoir temperature should be 60-68 degrees F.
Do not store product in direct sunlight. Do not freeze.
Mixing Instructions
For hydroponics, foliar feeding, and soil applications:
10 ml Plant Amp per gallon of water
For drain-to-waste systems
Adjust pH of solution before the addtion of Plant Amp. Do not adjust pH after addition of Plant Amp.